Axon Trailer One-Stop Solution

User Manual
1) Connect the positive (Red) cable to the positive terminal of the battery and connect the negative (Black) cable to the negative terrinal of the battery.
2) Connect the power outlet (110 VAC/60Hz) to the 3-prong plug of the battery Charger.
3) The LED of battery charger will indicate the status of the charger.
4) The LED of battery tester will indicate the status of the battery and alternator/charging system.
5) To test a battery, the vehicle's engine and lights etc. must be turned off and AC power must be unplugged.
6) To test an alternator/charging system, the engine must be running at 2,000rpm minimum and lights and accessories must be turned off (Note: testing results will read incorrect when connected to AC power).
7) Then simply push the "PUSH" button to get your test results.

Disconnect the AC power before installing battery to charger
Use ony with 12Volt Lead-Acid Battery
Litespan wil be shortened if working in environment such as much moisture and high temperature

LED indication
Charger
LED Light		Description		On/OFF	Condition
Green		Input AC Powe		On	AC power is present.
				Off	Check wall receptacle for 110 volts or check lead connections.
Red/Green		Charging Status		Red On	Charging
				Green On	Charged or trickle charging

Battery & Alternator Condition Tester
Red	Yellow	Blue	Green	Condition		Remedy
Off	OFF	OFF	OFF	Battery is dead (below 11.2V).		Please repair or replace it.
ON	OFF	OFF	OFF	Battery is poor (11.2 to 11.6V)		Please stop work and charge it to fully.
ON	ON	OFF	OFF	Battery is fair (11.7 lo 12.2V).		Please charge it to fully.
ON	ON	ON	OFF	Battery is good (12.3 to 13.6 V).		Please charge it for maintaining.
ON	ON	ON	ON	Alternator/charging system is good.
--	--	--	OFF	Alternator/charging system is good.		Please repair it.

Trouble shooting when charger doesn't work:
1. Check to make sure the power connected rightly to AC120V
2. Check whether battery terminals are in good touching with wire clip of charger, if terminals are oxidized, clean and connect again.
3. Check whether battery terminals are rightly connected with wire of charger, if connected reversely, connect again rightly.
4. Check whether a battery over DC12V was connected, use only with DC 12V Lead-Acid Battery please.
5. Check whether the body of charger is over 65 C, it will start to work again after cool down.
6. Check to make sure there is no short circuit or over currency on output.
7. Check battery with battery tester or Multi-Meter, if battery is too low, plase repair or change batter
8. Please stop charging if battery gets hot, if battery is bad, please repair or change battery.

Battery Charger with Tester: SCT -L1MP
DC12V/8Amp, 3 Charging Steps, Panel Mountate Battery Charger with "Push Button" Battery/ Alternator Tester

Specification

Input	AC 120 V, 60Hz	Lead Wire	3-Prong Plug
Output	DC 12V, Max. 9.5 Amp	Battery Cables	24 inches, 16AWG
Charge Current	Max. 9.5Amp	Body Size	153x105x52mm
Type of Battery Used	12V Lead-Acid Battery	Weight	0.8kg
Efficiency	>85%	Shell Material	Aluminum

Description of Charger
• Max 8Amp charger for 12V battery with 3 charging steps by PWM technology as follow:
1) Constant-Current Charge---when the battery voltage is lower than set point,it will charge the battery at the max. current which is called quick charging.
2) Constant- Voltage Charge---when the battery is almost been fully charged, the charger will limit the current automatically.
3) Float Charge---when the battery voltage reaches the float voltage of 13.5V, it will automatically switch to the float charging condition with current of 0.1A-0.8A.
• LED indicates power and stage of charging
• Reverse polarity protection & Output short circuit protection & AC input protection
• Over charge protection & Over thermal protection

Description of Battery/Alternator Condition Tester
•LED indicators verify the conditions of battery and alternator/charging system
•Monitor the condition of battery and alternator/charging system with a "Push Button"
•Press a "Push Button to know when replacement is actually needed